Factors That Affect Your Drainage System

Pipe failure is the main reason why houses suffer from water leakages. There are a lot of reasons why the piping system can have corrosions. Even the water that is drinkable can have corrosion effects on your pipes. This can be caused by several factors which are:
• pH of water
• Temperature of the water
• Water Chemistry
• Pressure of the water in your pipe
• Oxygen of water
pH of Water
The acidity of the water can be measured using the pH scale. This scale can be ranged from 0 to 14. The neutral point is 7 when it goes towards 0 it means that the acid increased; if it goes toward 7 to 14 the alkaline is increasing.

When the pH of the water is lower than 8 the copper pipe barrier can dissolve and this can cause corrosion. This can result to damage holes and pinhole leaks. 

Water temperature and Oxygen
If the water source you have in your house is from an “open” source, this means that it is continuously being replenished to be oxygenated and fresh water. But because of this oxygen, the metal on your pipe degrades and it’ll become rusty. This will result to water colouring and leakage.

Water velocity
This happens when the flow or turbulence of the water suddenly changes. Early leak detection is important in order for you to identify the appropriate methods to fix it. Usually, the traditional way to repair these kinds of damages is by repairing or replacing the pipes or tearing down your walls. This can be really expensive for the equipment that would be used and the cost of labour for your plumbers.

When all of these repairs are done, it is still unsure if the corrosion won’t come back again unless the causes has been corrected and repaired.

With the innovation of technology, plumbers now use non-destructive methods to check and listen for any hissing sound if there is any you can be sure that there are leakages. This means that they don’t have to break any walls or pipes in your house.

For easy leak detection, these newly innovated companies use CCTV to inspect your pipes and drains. Not only that, they’ll also check your drain cleaning at Melbourne systems and underground pipelines. With this technology, they can also find issues on your concealed walls, hydronic heating systems under concrete and bitumen roads and irrigation and sprinkle systems.

If you’re going to look for a plumbing company for your drainage problems, make sure that you can have an all-in-one service. They will not fully look for leaks inside your house, but they will also go beyond and check all lines that could contribute to the problems.